Speedkid2 2018
Subject to change. 12|2017 –
21
Utilisation
Tip!
Carry the buggy wheel e.g. in the storage space in order to allow you to use the flexibly
at your destination. Instructions for re-mounting it can be found in the chapter
„Installing
the buggy wheel“ on page 16.
Setting the wheel so that it turns freely (Buggy mode)
It must be possible for the wheel to move freely through 360° in order to manoeuvre in Buggy mode.
f
Push up the mode switch to release the wheel.
Securing the wheel (Walker mode)
In Walker mode, the wheel must not be at an angle to the direction of travel. You must lock the
wheel to run straight ahead in order to prevent abrupt blocking.
f
Push down the mode switch to make sure the wheel is running straight.
f
Turn the positioned wheel backwards until it engages audibly.
Insert tow bar
The tow bar can either be brought forward into the attachment position or carried along backwards
in the standby position: Pay attention also to the instructions in the chapter
„Mounting the tow bar“
on page 16
.
Danger!
Wrap the retaining strap of the tow bar around the tow bar several times to ensure it
does not hang down in the standby position. Otherwise it could become trapped on
obstacles.
Using the pennant
The pennant must be attached in Trailer mode, see
„Inserting the pennant“ on page 15
. For safety
reasons, we also recommend this for the other modes.
Attaching the hand strap
In Buggy and Walker mode, the hand strap secured to the push handle must be attached to your
wrist during every journey.
Putting on the 5-point safety harness
In every mode, the 5-point safety harnesses must be properly adjusted and every child must be
fastened in, see
„Adjusting the safety harnesses“ on page 22
.
