Sportrex 2020
Subject to change. – 12|2019 –
13
»
Hold the wheel axle with the leaf springs to the
lead spring seat.
»
Turn the four screws through the leaf spring in the
leaf spring seat.
»
Tighten the screws with the hexagon socket head
cup screws firmly.
»
Make sure that the red leaf spring plates align
parallel with the silver leaf spring seat so that the
axle is centered.
Assembly
Tip!
If the holes of the red leaf spring plates don't align with the ones in the leaf spring seat,
loose the screws which connect the red leaf spring plates to the axle. Afterwards it is
possible to move the red leaf spring plates until the holes align properly. Remember to
tighten the screws again.
Inserting the wheels
»
Remove the black rubber caps from the ends of the
thru-axles and then dispose of them.
»
Lift the cabin a little bit or place the cabin on its
roof in order to install the wheel easier.
»
Insert one wheel into the cabin’s axle retainer:
–
Hold the wheel so that you can press your
thumb onto the rubber cap on the outside of
the wheel hub.
–
Press on the rubber cap and keep it pressed in
order to open the push-in axle fastening.
–
Insert the wheel’s push-in axle as far as it will go into the axle retainer.
–
Release the rubber cap to secure the push-in axle.
»
Pull on the wheel to check that the wheel is locked in the axle retainer.
»
Insert the second wheel in the same way.
»
Check whether there is sufficient air in the wheels (recommended air pressure: 2.5 – 3 bar).
If necessary, use an air pump for car valves to top up with air.
Installing the wheel guard and the leaf spring cover
The wheel guard on both sides of the cabin prevents
the wheels from getting stuck on pillars or similar
obstacles. The leaf spring covers serve as protection
against bruises.
»
Make sure that the slide covers for the wheel guard
and leaf spring cover are fixed and tightened on
both side