18
– 12|2019 – Subject to change.
Sportrex 2020
Assembly
Optional assembly steps
Installing the buggy wheel
You need the buggy wheel for Buggy and Walker mode. The buggy wheel is connected directly
with the wheel suspension attached to the frame and is
mounted so that it can rotate through 360 °.
»
Lift the cabin at the front.
»
Place the buggy wheel into the wheel mount as far
as it will go, until it engages audibly with a clicking
noise.
»
Check whether there is sufficient air in the
buggy wheel (maximum air pressure: 1.9 bar). If
necessary, use an air pump for car valves to top up
with air.
Adjusting the buggy wheel
»
Set with the release button
a
and
mode selector switch (unlock key)
b
in front
of the suspension the desired operating mode:
–
Buggy mode: Buggy wheel rotatable
through 360 °.
–
Walker mode: Buggy wheel running straight.
–
Trailer mode: unfasten and pull out
the buggy wheel.
Mounting the tow bar
You only require the tow bar in Trailer mode. It is used to hook up the
Sportrex
behind a bicycle
equipped with a suitable coupler, see
Connecting the trailer to a bicycle
on page 28.
The tow bar is attached to the tow bar mount using a locking bolt and can be used in two
different positions:
»
Attachment position: The tow bar is facing forwards.
»
Standby position: The tow bar is facing to the rear and is carried under the cabin floor.
In both positions, the tow bar is also secured with a cotter pin.
»
Pull the locking knob with one hand and
hold it in place.
»
Push the front button on the tow bar with
the other hand so that the locking bolt unlocks.
»
Keep on pushing down the button and push the
tow bar forwards until the mark in the tow bar
mount is reached.
»
Release the button so that the locking bolt secures
the tow bar in the tow bar mount.
»
Release the locking knob so that it jumps back into
the closed position and additionally secures the
tow bar.
a
b
