MAIN MENU GUIDE
QT518 & QT5116 User Manual
37 |
P a g e
4.2.7 Network Configuration
This unit supports DHCP, PPPoE and DDNS. To access these functions, from the Pop-Up Menu illustrated in Fig 4.3
System Setup, select Network and a user interface for all the Network functions available will appear as illustrated in
Fig 4.13 Network Configuration. Here, you can configure the IP Address associated with your system, the DDNS
server you wish to use, the video transmission parameters and the various port settings.
Fig 4.13: Network Configuration
The following are the definitions for each option available through the Network Configuration window:
HTTP Port:
The default is 80. If users change the value, they need add the port number when typing the IP address
in IE address blank, i.e. set HTTP port to 82, IP address to 192.168.0.25. Users need input http://192.168.0.25:82 in
IE browser.
Server Port:
Communication port, 2000 by default
DHCP:
Enable DHCP. For this feature to work you need to enable DHCP in the router or virtual server. When enabled
the unit will get IP address information automatically from the router instead of inputting IP, Subnet, and Gateway
manually. After you allow the router to assign the addresses you should go to the info button on the DVR or remote
and see what addresses where assigned, and then go back to the Network Configuration, remove the checkmark
from DHCP and manually enter the IP addresses assigned by the router into the spaces. This way your addresses
will not change if the system is rebooted.
IP, Subnet, Gateway, DNS1 and 2:
IP address information. If users don’t enable DHCP it is necessary to input the
IPs manually here.
PPPoE:
Enable PPPoE. If users connect the DVR to internet directly by a DSL, not through a router or a virtual
server, enable this option.
User Name, Password:
Account information of PPPoE. Input information you get from your ISP.
DDNS:
Click DDNS, a window will appear as shown in Fig 4.14 DDNS Configuration. This DVR supports MYQ-SEE
and DYNDNS. Users need to register for their account at
myq-see.com
or
www.dyndns.com
. Then input registered
ID and password here. Click OK button. The unit will connect through MYQ-SEE or DYNDNS.
