Pro Video Instruments
VeCOAX MicroMod 3 AV + HDMI RF Modulator Manual
2
NOTE: BEFORE INSTALLATION
Please test each unit UNMOUNTED ON A TEST BENCH with your Test TV before installing your units to
ensure you are receiving the Test Pattern signal. Then Program your unit. If installing Multiple units,
make sure each unit has its own frequency it's broadcasting on as well as
it’s own
Major/Minor.
This makes troubleshooting easier.
To test your unit, simply connect your TV with a short piece of Coax cable to the RF out of the Unit. No
HDMI needs to be connected for this test.
Scan for channels on the connected TV. Depending on your supported TV standards, scan for digital
channels.
After the scan is complete, you can tune to channel 1.1, and the test pattern will be visible.
By default, our unit is set to QAM (J.83B Cable) mode. To configure the unit beyond the default
settings, see the
WEB INTERFACE
CONFIGURATION GUIDE
on Page 6 for web interface setup, or see
the
ON-BOARD DISPLAY
on Page 10 to use the on-board menu.