Nixie Tube Clock ‘Nixie QTC+’
2 (01 October 2018)
www.pvelectronics.co.uk
- 24 -
scissors as shown below. Start at one of the leads at the back of
the tube.
Then, working around the tube, cut each sucessive lead approx
2mm shorter than the previous one. This will allow you to feed
each lead in in turn.
Now you can insert and solder in the tube.
There are 11 leads on the trimmed tube and 12 pads on the PCB.
One of the pads on the PCB is unconnected. DO NOT INSERT A
LEAD INTO THIS HOLE:
Insert from the side of the PCB with no markings.
Pay attention that the tube sits squarely on the PCB.
Then solder on the connector.
Summary of Contents for Nixie QTC Plus
Page 57: ...Nixie Tube Clock Nixie QTC 2 01 October 2018 www pvelectronics co uk 57 ...
Page 59: ...Nixie Tube Clock Nixie QTC 2 01 October 2018 www pvelectronics co uk 59 13 CIRCUIT DIAGRAM ...
Page 60: ...Nixie Tube Clock Nixie QTC 2 01 October 2018 www pvelectronics co uk 60 ...
Page 61: ...Nixie Tube Clock Nixie QTC 2 01 October 2018 www pvelectronics co uk 61 ...
