Nixie Tube Clock ‘Nixie QTC+’
2 (01 October 2018)
www.pvelectronics.co.uk
- 19 -
5.
ASSEMBLING THE NIXIE TUBE CELLS
PLEASE REFER TO THE APPROPRIATE SECTION FOR YOUR NIXIE
TUBE TYPE.
5.1 IN-14 Nixie Tubes.
Code configuration: A (see page 36)
Cell PCB Type:
Start by identifying the anode lead at the back of the tube. It has a
white coating where it enters the glass. Then remove the wires
each side of the anode.
To facilitate easy insertion of the flying leads into the small holes, it
helps enormously to trim the flying leads with a pair of scissors as
shown below.
Start at the anode lead, then, working around the tube, cut each
sucessive lead approx 2mm shorter than the previous one. This will
allow you to feed each lead in in turn.
Summary of Contents for Nixie QTC Plus
Page 57: ...Nixie Tube Clock Nixie QTC 2 01 October 2018 www pvelectronics co uk 57 ...
Page 59: ...Nixie Tube Clock Nixie QTC 2 01 October 2018 www pvelectronics co uk 59 13 CIRCUIT DIAGRAM ...
Page 60: ...Nixie Tube Clock Nixie QTC 2 01 October 2018 www pvelectronics co uk 60 ...
Page 61: ...Nixie Tube Clock Nixie QTC 2 01 October 2018 www pvelectronics co uk 61 ...
