PURSUIT 3400 Express Fisherman, Owner'S Manual

Page: 95 / 162

6 . 6 . 5 . Raw Water Intake Strainers
The engine raw water intakes (see Figure 6-6), generator raw
water intake, air conditioning raw water intake, and raw water
washdown pump intake are equipped with strainers. The strain-
ers should be checked each time you use the boat to assure that
no debris has accumulated that may block the flow.
If they are clogged and need cleaning, follow this procedure:
1. With the related equipment not operating, close the
seacock, at the hull bottom, to stop the flow of water.
2. Remove the top of the filter by unscrewing
counterclockwise. A spanner wrench has been
provided for this purpose.
3. Lift the strainer out by the handle on the top.
4. Remove any debris from the strainer screen and rinse
with clean water. Check to be sure that the O-ring
under the top is intact and replace if necessary.
5. Install the strainer, replace the cover, and tighten with
the spanner wrench.
6. Open the seacock, start the related equipment, and
check the system for leaks.
6 . 7 . HEAD SYSTEM
The head in your 3400 Express Fisherman comes
supplied with operating and maintenance instructions from the
manufacturer. Schematics of the three head systems available
are shown in Figures 6-7 thru 6-9.
When the holding tank (located under the floor, forward) is full,
it is necessary to pump it out. To do this:
1. Take your boat to a marine facility where a pump out
station is located.
2. Remove the cap from the waste deck fitting, located on
the starboard side deck, at the front of the side
Rev. A 05/02/99
ROUTINE MAINTENANCE HEAD SYSTEM
3400 Express Fisherman 6-15