PURSUIT 3400 Express Fisherman, Owner'S Manual

Page: 107 / 162

3. Run the pump for a few seconds to be sure there is no
water left in it. Re-connect the hoses to the pump and
re-assemble the strainer.
When reconnecting raw water hoses, be certain to
tighten clamps well. Leaking fitting on raw water
hoses can sink the boat.
4. The system can be filled with an anti-freeze mixture.
Refer to the air conditioning manufacturer’s owner’s
manual for the recommended procedure.
7 . 5 . 2 . Head System
The first thing that must be done is to pump out the holding
tank. Before doing so, drain the water from the fresh water
system and run the toilet, without incoming water, to drain the
hose running from the toilet to the holding tank.
Take your boat to a facility with the required pump-out facilities
and follow the procedure outlined in Section 6.7.
If desired, flush 1-2 gallons of potable anti-freeze into the system.
When reconnecting raw water hoses, be certain to
tighten clamps well. Leaking fittings on raw water
hoses can sink the boat.
Note: Schematics of all head systems are located in Chapter
6, Routine Maintenance.
7 . 6 . ENGINE ROOM AND BILGE AREAS
All the bilge areas, forward under the floor, engine room, and
aft under the cockpit, should be wiped clean. The hoses leading
from the bilge pumps forward, in the engine room and under
the cockpit floor, should be disconnected from the pumps and
drained. Any bilge water should then be removed with a sponge
and wiped dry.
Rev. A 05/02/99
CAUTION
CAUTION
STORING AND WINTERIZING YOUR BOAT ENGINE ROOM AND BILGE AREAS
3400 Express Fisherman 7-7