PURSUIT 3400 Express Fisherman, Owner'S Manual

Page: 78 / 162

dures recommended by the generator manufacturer in their
owner’s manual.
5 . 3 . 3 . Engines and Transmissions
The alignment between the transmission flange and propeller
shaft flange must be checked before leaving the dock for the first
time (see Figure 5-5). While this alignment is set before the boat
leaves the factory, the boat may settle after shipment and then
again when being put in the water. This must be checked and
adjusted, if necessary, by your Fishing Boats dealer
or a qualified marine service facility. The alignment should also
be checked seasonally.
The alignment should also be checked again at 25 hours,
whenever the boat has been out of the water for an extended
period, or at least once a year. If it is not within tolerances
indicated in Figure 5-5, you must have it adjusted.
Check the engines and transmissions for proper oil and coolant
fluid levels. Start your engines and check to see that they are
operating properly. Check your engine manufacturer’s owner’s
Rev. A 05/02/99
Transmission Flange
Propeller Shaft Flange
.05mm
(.002") max.
Figure 5-5: Propeller Shaft / Transmission Coupling
AFTER LAUNCHING YOUR BOAT COMMISSIONING YOUR BOAT
5-8 3400 Express Fisherman