PURSUIT 3400 Express Fisherman, Owner'S Manual

Page: 51 / 162

9. Put the switch for the blowers in the ON position. The
switch is located on the helm switch panel.
To reduce the risk of fire, investigate all fuel odors
immediately and do not start the engines, or other
electrical equipment, other than the blowers.
10. Check the engine room and bilge areas for fuel odors.
If you smell fuel, do not start the engines or other
electrical equipment. Investigate the cause, correct,
and completely ventilate the bilge area before
proceeding.
3 . 1 . 3 . Filling Your Water Tank
The fill fitting for the water tank is located on the starboard side
deck, near the aft spring line cleat. To fill:
1. Open fill fitting with special key provided.
2. Insert hose from dockside water supply and turn on.
3. Stop filling when water overflows fitting and comes out
of the vent fitting on the hull side below fill fitting.
4. Replace cap and tighten.
3 . 1 . 4 . Starting Your Engines
Before starting your engines, be sure that you have performed
all the maintenance checks listed under Section 3.1, When
Arriving at Your Boat. To start your engines, follow these steps:
1. Turn the ignition switches, located on the D.C. main
distribution panel, to the ON position.
2. Open all hatches to the bilge area and operate the
blower for at least four minutes. Investigate and
remedy any fuel vapors that are detected.
Rev. A 05/02/99
CAUTION
WHEN ARRIVING AT YOUR BOAT OPERATING YOUR BOAT
3-4 3400 Express Fisherman