ZENITH 140
INSTRUCTION MANUAL
40
Set-up Your Application
Once you have chosen the application, you will see a ‘Wait…’ message while
the parameters are all calculated and stored. Next you will see the
parameters needed to finalise your application, in turn, as shown below. If
you know you don’t need to change fro
m the default, you can use the right
arrow key to scroll through them, but if you want to view or change each
one, just press ENTER.
PARAMETER
DEFAULT
DESCRIPTION
P101 Transducer
2 = dB6
Type of transducer being used.
P102 Material
1 = Liquid
Material in the vessel, either liquid or
solid. If the solid lays flat, then it can be
programmed as liquid.
P104 Measurement
Units
1 = metres
Select units to be used for programming
measurement information.
P105 Empty Level
6m
Distance from the face of the transducer
to the material at the bottom of the
vessel.
P106 Span
5.7m
Distance from the empty level (0% full) to
span (100% full).
For More Options Hit Enter
Now you will see a scrolling message that says, ‘For more Options
Hit
Enter
’. If you press ENTER, you will then see more parameters, specific to the
application you have chosen, these are all factory pre-set. If you press any
other key you will return to the Quick Setup menu, where you can press
CANCEL to return to run mode.
