Pulsar QUANTUM3, Instruction Manual

Page: 33 / 207

Page
25
Note
You can tell which part of the menu system you are in, as the up/down
indicators, (arrows) next to the bar graph will indicate as follows:
•
Top level menu : Down arrow on , to indicate you can move down.
•
Sub-menu : Up and Down arrows on , to indicate you can move up to
the top level, and down to parameter level.
•
Parameter Level : Up arrow on , to indicate you can move up to sub-
menu level.
•
Parameter Editing : No arrows on.
Directly Editing Parameters
If you already know the number of the parameter that you wish to look at or
edit, simply type the number in at any time while you are in the menu system.
Thus, if you are in either the menu or sub-menu level, by pressing a numeric
key you can enter the parameter number directly and jump straight there. You
cannot type a parameter number whilst at parameter level, only at one of the
two menu levels.
When you are at a parameter the text line rotates automatically displaying the
parameter name, number, the applicable units and the maximum and
minimum figure you can enter. The top line shows the value you are setting.
Once you have accessed a parameter you can either just look at it, or change
it.
Once a parameter has been changed, press
ENTER
and you will see the
message “
Saved!
” If you press
CANCEL
, then the change you made will not
be saved, and the message “
Unchanged!
” will be displayed.
TIP
You can jump straight to the last parameter you
edited, by pressing ‘+/ - ’ when you first enter
program mode.