Pulsar blackbox 134, Instruction Manual

Page: 79 / 121

Page
71
System Information
The following three parameters do not affect how the unit performs, but details,
contained in them, may be required, by Pulsar, when making technical enquiries.
P926 Software Revision
This parameter will display the current software revision. It is read only, and
cannot be changed. The
software revision can also be viewed, while in RUN
mode, by pressing the decimal point key when using any of the display
options.
P927 Hardware Revision
This parameter will show details of the current hardware revision. It is read
only and cannot be changed.
P928 Serial Number
This parameter will display the current unit’s serial number. It is read only,
and cannot be changed. The
serial number can also be viewed, while in RUN
mode, by pressing the decimal point key when using any of the display
options.
P929 Site Identification
This parameter allows you to give each unit an individual reference number,
for identification purposes. You can set any number between 1 and 99999.
P930 Factory Defaults
This parameter resets all parameter values to the original Factory Set values
that were installed when the unit was tested, before despatch to you.
To reset parameters, enter 1 ( Yes ), and press
ENTER
, then you will see a
message “
Entr if sure
”, you should press
ENTER
again. If you press any other
key at this point, the parameters will not be reset, and you will see a message
confirming this.
Once you have done this, program the unit, to the desired application.
Date & Time
The date and time is used, to control specific relay functions and date stamp
certain events that are contained in the Data Logs.
P931 Date
This parameter shows the current date , in the format as set by P933 ( Date
Format ), and can be reset if required.