Pulsar blackbox 134, Instruction Manual

Page: 71 / 121

Page
63
P601-P603 Vessel Dimensions
These three parameters are used to enter the dimension required to calculate
the volume. The dimensions required are as shown below and are entered
Measurements Units ( P104 ).
Vessel Shape P601 P602 P603
P600=0
Cylindrical Flat base Cylinder
Diameter
P600=1
Rectangular Flat base Width of
rectangle Breadth of
rectangle
P600=2
Cylindrical Cone base Height of
base Cylinder
Diameter
P600=3
Rectangular Pyramid base Height of
base Width of
rectangle Breadth of
rectangle
P600=4
Cylindrical Parabola base Height of
base Cylinder
Diameter
P600=5
Cylindrical Half-sphere base Cylinder
Diameter
P600=6
Cylindrical Flat sloped base Height of
base Cylinder
Diameter
P600=7
Rectangular Flat sloped base Height of
base Width of
rectangle Breadth of
rectangle
P600=8
Horizontal cylinder flat ends Length of
Cylinder Cylinder
Diameter
P600=9
Horiz. Cyl. parabolic ends Length of
Cylinder Cylinder
Diameter Length of
one end
section
P600=10
Sphere Sphere
Diameter
P604 Calculated Volume
This parameter displays the maximum volume that has been calculated by the
blackbox
and is a Read Only parameter. The volume displayed will be shown
in Volume Units (P605) and is the total volume available between empty
level ( P105) and 100% of span ( P106 ).