Page 2 of 52
PULSAFEEDER FACTORY SERVICE POLICY
Upon receipt of your new PulsaPro diaphragm-metering pump, activate the warranty by registering
the serial number at
http://www.pulsa.com/warranty-registration
. Should you experience a
problem with your
PulsaPro
pump, consult the troubleshooting guide in your operation and
maintenance manual. If the issue is not covered or cannot be solved, contact your Pulsafeeder Sales
Representative or contact the Pulsafeeder Service department directly.
Parts purchased to correct a warranty issue may be credited after an examination of original parts by
Pulsafeeder. Warranty parts returned as defective, which test good, will be sent back freight collect. No
credit will be issued on any replacement electronic parts. If the product requires returning to the factory for
inspection and/or repair, a Return Authorization Number (RMA) issued by Pulsafeeder is mandatory. To
request an RMA, contact your local sales representative for an authorization form.
TRADEMARKS
PulsaPro
®
is a registered trademark of Pulsafeeder, Inc.
Pulsafeeder
®
is a registered trademark of Pulsafeeder, Inc.
SAFETY CONSIDERATIONS
•
Read and understand all related instructions and documentation before attempting to
install or maintain this equipment
•
Observe all special instructions, notes, and cautions.
•
Act with care and exercise good common sense and judgment during all
installation, adjustment, and maintenance procedures.
•
Ensure that all safety and work procedures and standards that are applicable to your
company and facility are followed during the installation, maintenance, and operation of
this equipment.
Copyright ©2017 / 2020 Pulsafeeder, Inc. All rights reserved.
Information in this document is subject to change without notice. No part of this publication may be
reproduced, stored in a retrieval system or transmitted in any form or any means electronic or mechanical,
including photocopying and recording for any purpose other than the purchaser’s personal use without the
written permission of Pulsafeeder, Inc.
CONVENTIONS
A WARNING DEFINES A CONDITION THAT COULD CAUSE DAMAGE TO BOTH THE
EQUIPMENT AND THE PERSONNEL OPERATING IT. PAY CLOSE ATTENTION TO ANY
WARNING.
NOTES ARE GENERAL INFORMATION MEANT TO MAKE OPERATING THE EQUIPMENT
EASIER.
REVISION HISTORY
Revision # Implemented By
Revision Date
Approved By
Approval
Date
Reason
0.0
M. Groth
NEW
B. Montagno
05/23/2017
New Product Line
1.0
B Montagno
07/31/2018
M Lawton
08/01/2018 Drive Train Warranty Added
1.1
E Van Bork
10/23/2018
B Montagno
10/23/2018
Updated Stroke Lock
1.2
S. Farley
8/13/2020
H Maharajh
E Van Bork
09/03/2020
Updated Pictures Update
Priming Procedures
