40
rev. 7-2017 114A3873.D
Wireless Door Alarm System
Register Transmitters
Every transmitter has a unique identification number programmed
from the factory. The wireless multiplexer uses this identification
number to determine which transmitter is sending data. The
identification number is not the same as the channel number and
each transmitter must also be registered to a channel within the
wireless multiplexer before it will function.
Once a transmitter is registered with a channel, the multiplexer
looks up the transmitter’s channel number when it receives data
from the transmitter. This helps prevent unwanted or unknown
signals from interfering with system operation.
Transmitters can be registered one at a time or in a group. Use
the,
REGISTER A SINGLE TRANSMITTER,
when adding
or replacing a transmitter. Use the
REGISTER A RANGE OF
TRANSMITTERS
when adding several transmitters to a site at
one time.
Register a Single Door Transmitter
The process for registering a single door transmitter is shown in
Drawing 17 on page 41. The displayed messages are shown to
the right of the prompts.
To begin, press the
*
key on the multiplexer until the
REGISTER
A SINGLE DOOR TRANSMITTER
message displays, then press
the # key.
The multiplexer will beep when it recognizes the reset of a
transmitter. This is an audible signal that the transmitter has been
registered
When the multiplexer is waiting for a reset on a transmitter, the
timeout is disabled and you must manually complete the operation
using the keypad.
