Wireless Door Alarm System
35
114A3873.D rev. 7-2017
Backup Baud Rate
This function sets the baud rate for the serial port on the mux, used
to communicate to the RX900 backup / restore utility program.
The factory default setting is 19200 baud.
Change Setup Password
Change the Setup
Password?
Press
*
to Change,
PRESS # WHEN DONE
Change Setup Password changes the factory default setup
password. While this message is displayed, press the
#
key, the
multiplexer will prompt for a new numeric password.
Enter the new password, enter the same new password again for
verification. If both entries match, the new password will be set
and the display will continue to the next parameter.
If the passwords do not match, the display will show a warning that
the passwords do not match and then revert back to the ‘Change
Setup Password’ screen.
Backup Baud Rate:
19200 baud
Press
*
to Change,
PRESS # WHEN DONE
