Operation, Calibration & Service Manual
LinkBelt - DS350 1334 Console
Step J4:
Boom to the indicated angle
0.5
. Take a radius
measurement from the centerline of rotation to the block/ball. Enter
the actual measured radius.
NOTE: There is to be no load on hook
at this time.
Use the + and
– button to change the value shown.
Press OK when complete.
Note: the angle will be automatically selected based on the
maximum angle allowed by the selected operating mode.
Step J5:
Lift a test load that is near the maximum allowed load for
the indicated angle. Be sure to consider all required deductions.
Enter the weight of the load to match the load on hook (including
the hook block or overhaul ball, and any rigging). Adjust the weight
to the nearest 100 lbs. above the actual weight Include all load
handling devices. Use the + and
– button to change the value
shown. Press OK when complete.
NOTE: Known loads, weight is depended on configuration,
loads should be within 50 to 75% of max load for the defined
radius. To comply with SAE J376 standards, the test load must
be to a known accuracy of
1%.
Step J6:
With test load still on hook block/ball, take a radius
measurement from the centerline of rotation to the block/ball. Use
the + and
– button to change the value shown. Press OK when
complete
