Operation, Calibration & Service Manual
LinkBelt - DS350 1334 Console
Step 4:
Boom to indicated angle
0.5
. Take a radius
measurement from the centerline of rotation to the block/ball.
Enter the actual measured radius.
NOTE: There is to be no load
on hook at this time.
Use the + and
– button to change the value
shown. Press OK when complete.
Note: the angle will be automatically selected based on the
maximum angle allowed by the selected operating mode.
Step 5:
Lift a load that is near the maximum allowable load for the
indicated angle and the given configuration. Be sure to consider all
required deductions.
Enter the weight of the total load to match the load on hook
(including the hook block or overhaul ball, and any rigging). Adjust
the weight to the nearest 100 lbs. above the actual weight Include
all load handling devices. Use the + and
– button to change the
value shown. Press OK when complete.
NOTE: Known loads, weight is depended on configuration,
loads should be within 50 to 75% of max load for the defined
radius. To comply with SAE J376 standards, the test load
must be to a known accuracy of
1%.
Step 6:
With test load still on hook block/ball, take a radius
measurement from the centerline of rotation to the block/ball.
Enter the actual measured radius. Use the + and
– button to
change the value shown. Press OK when complete
