Operation, Calibration & Service Manual
LinkBelt - DS350 1334 Console
Main Boom Calibration
Step 1:
Boom to indicated angle
0.5
. With the hook block
suspended, enter the weight of the hook block.
NOTE: There
is to be no load on hook at this time.
Use the + and
– button to
change the weight to the nearest 100 lbs. above the actual
weight of the hook block or overhaul ball. Press OK when
complete.
Note: the angle will be automatically selected based on
the minimum angle allowed by the selected operating
mode.
Step 2:
Boom to indicated angle
0.5
. Take a radius
measurement from the centerline of rotation to the block/ball.
Enter the actual measured radius. Use the + and
– button to
change the value shown.
Press OK when complete.
Note: the angle will be automatically selected based on
the minimum angle allowed by the selected operating
mode.
Step 3:
Boom to indicated angle
0.5
. Take a radius
measurement from the centerline of rotation to the block/ball.
Enter the actual measured radius.
NOTE: There is to be no
load on hook at this time.
Use the + and
– button to change the
value shown. Press OK when complete.
Note: the angle will be automatically selected based on the
following formula:
max
angle
min
angle
2
min
angle
Indicated angle
Actual angle
