PSG CADDY ALTERNA II, Installation And Operating Instructions Manual

Page: 11 / 108

11
WARNING: Avoid knocking or scratching the glass. It might crack or break.
Do not operate your furnace with a broken glass, as this could seriously damage your furnace and cause ashes
to be dispersed through the ductwork.
4.7.1 GLASS SPECIFICATIONS
The glass
is made of 3/16” (5 mm) thick Pyroceram.
You can purchase a replacement glass from your PSG dealer.
4.8 ASH DRAWER
Your furnace is equipped with an ash drawer to collect ashes produced by the combustion of pellets. The
drawer must not be left open during combustion as this may cause ash dispersion through the ductwork.
The
drawer must be emptied regularly. Once clean-up is completed, use an ash vac to carefully remove any
ash around the drawer. Failure to perform this important step may cause ashes to be dispersed through
the ductwork.
5 APPLIANCE INSTALLATION
WARNING: DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE OR REPAIRS ON THE
FURNACE.
5.1 REMOVING THE HOPPER AND BLOWER ASSEMBLY (IF REQUIRED)
Should you need to install the furnace in an area that if difficult to access, both the hopper and blower assembly
located at the back of the furnace may be removed. To do so, follow the instructions below.
Also, it is important that the door and the ash drawer be kept closed while the appliance is in
use. Maintain all gaskets in good condition; in case of deterioration contact your dealer for a
genuine replacement gasket.