PSG CADDY ALTERNA II, Installation And Operating Instructions Manual

Page: 10 / 108

10
4.2 ODOR FROM THE PAINT
It is normal that smoke and odors emanate from the unit when you first light it. This is due to the paint curing
process. It is recommended to burn the unit at a high rate and ventilate the furnace room and the building until
the odors disappear. The smoke is not toxic.
In order to prevent the spread of smoke throughout the
building, this step should be performed before the furnace is connected to the ductwork.
4.3 ASH DISPOSAL
Ashes must be placed in a metal container with a tight-fitting lid. The container should be stored outdoors, well
away from combustible materials. This container should not receive any other type of waste. If the ashes are
meant to be buried in soil, wait until all embers have thoroughly cooled before burying.
4.4 CREOSOTE BUILD-UP AND REMOVAL
When fuel is burned slowly, it produces tar and other organic vapors which, when combined with moisture, form
creosote. The creosote vapors condense in a relatively cool chimney flue. As a result, creosote residues
accumulate on the flue lining.
When ignited, creosote produces an extremely hot fire inside the chimney.
In the first year of use, in order to avoid chimney fires, inspect the chimney system at regular intervals to
determine a cleaning cycle. Depending on the type of pellet used and its quality, a semi-annual cleaning may be
required. A yearly cleaning is mandatory.
If a significant layer of creosote has accumulated, it must be removed immediately to eliminate the risk
of chimney fire.
It is highly recommended to prepare an emergency procedure in case of a chimney fire.
It is recommended to clean the heat exchangers thoroughly at the end of the season in order to prevent
corrosion.
N.B.: In order to obtain the minimum fuel moisture rate and optimize the efficiency of the unit, store the
combustible in a dry place. Do not store fuel or combustible materials within the installation minimum clearances
or the space required to reload the appliance and remove ashes.
4.5 SOOT AND FLY ASH (FORMATION AND NEED FOR REMOVAL)
The products of combustion will contain small particles of fly ash. The fly ash will collect in the exhaust venting
system and restrict the flow of the flue gases. The exhaust venting system should be inspected at least once
every year to determine if cleaning is necessary.
4.6 SMOKE DETECTOR
We highly recommend the use of a smoke detector. It should be installed at least 15 feet (4,57 m) from the
appliance.
4.7 DOOR GLASS
Fly ash will cause the glass to become dirty after a full hopper of pellets has been burned. If you can still see a
fire in the burn pot, you do not need to clean the glass immediately. However, when it becomes difficult to see
the orange glowing produced by the fire, it is time to clean the glass. The frequency at which you clean the
glass will depend on the type of fuel you use and thermostatic demand. You will have to clean it using a wet
cloth and a fireplace cleaner. Clean the glass
ONLY when the unit has cooled down. Do not use abrasive
cleanser. Fireplace glass cleaners are available in most home centers and specialty hearth retailers.