ProX Blitzz Operators Manual
Page 3
Version: 1.35 (8/7/2018 5:32 PM AD)
•
USE PROX SPARK POWDER ONLY!
•
CERTIFIED ADULT OPERATOR USE ONLY
•
DO NOT OPERATE WITHOUT SPARK POWDER.
•
DO NOT SHOOT TOWARD THE AUDIENCE OR PEOPLE.
•
ALLOW MINIMUM 10FT BETWEEN THIS DEVICE AND SPECTATORS/GUESTS.
•
KEEP DRY - IP20
•
DISCONNECT POWER BEFORE CHANGING FUSE.
•
DO NOT OPEN THE CASE, RISK OF ELECTRIC SHOCK!
NO USER SERVICEABLE PARTS INSIDE.
Details:
1.
Spark Output
2.
Cap for Powder Loading
3.
Lifting Handle
4.
Safety Card Scan Area
5.
Digital Display
6.
On/Off Switch
7.
115V AC Power Out
8.
115V AC Power In
9.
DMX-512 Connector In
10.
DMX 512 Connector Out
11.
Wired Controller Connector (Single Machine Control)
Operation
•
Have the device operated by a qualified person, respecting IEC 60598-2-17 and all other applicable codes
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device annually and additionally before placing into service if stored for an extended
period of time.
•
Install the device in a secure location that is inaccessible to unauthorized persons.
•
Make sure there is no flammable material within a 10ft radius of the device.
1.
Open the carton and carefully remove the unit from the carton
2.
Set the Unit machine on a flat dry surface.
3.
Fill the powder reservoir with our ProX powder only then tighten the cap.
4.
Scan the safety card before use
5.
Firmly attach the remote control unit to the rear remote control socket on the unit.
6.
Plug the unit in to a proper power source. Wait several minutes for the device to reach normal operating
temperature. When it has reached the operating temperature, and is ready to operate with sparks, the
digital display board at rear will show “READ” and the ready LED on the remote will glow also.
7.
You can press wired controller or wireless controller to emit output.
Daisy chain the machines:
You may connect the machines with
