Provill BTP-2100E, User Manual, Page: 21 / 37

BTP-2100E USER MANUAL
Printer common parameter adjustment
Printer common parameter adjustment and range
Table 3.3.1
Parameter
Range
settings
Remarks
Print
darkness
00—30
Under the condition that the printout meets with the
requirement, set the print darkness as low as possible to
avoid THP’s lifetime effected.
Vertical
position
-99—99 dots
Adjust the printout in vertical direction with 1 dot as a motion
unit.
Horizontal
position
-99—99 dots
Adjust the printout in horizontal direction with 8 dots as a
motion unit. Print pattern hall not move when it is less than 4
dots, or the print pattern shall move based on 8 dots when it
is between 4 dots and 8 dots.
Tear-off
position
-99—99 dots
Adjust the tear-off position in vertical direction with one dot
as a motion unit.
Notice:
„ In 203DPI, 1 mm equals to 8 dots. In 300DPI, 1 mm equals
to 12 dots.
„ The parameters above have been adjusted when out of
factory. Please do not change them.
Print pattern on ticket (x,y) and adjusting direction
Vertical print position adjustment
When print ticket happens as Figure A or Figure B, adjust the vertical
print position to Figure C.
Figure 3.3.2
Notice:
„ Figure A shows the print position is upward
- 17 -