SLG™ BOLT
O-RING TABLE
SLG™ BOLT O-RING LIST
1
014 BN
90
2
016 BN
70
3
020 BN
70
4
005
BN 70
RE-COCKING / BLEED
The SLG™ is equipped with a Pneumatic re-cocking system in case the bolt becomes jammed
(pinching a ball). The button in the center of the bolt back can be pressed to send the bolt
rearward and reset it for the next shot. The bleed button also serves as a gas vent for the dump
chamber. It can be used to de-gas the SLG™ after the tank is removed, or to confirm that the SLG™
has gas and is ready for play.
The bleed button is also a safety mechanism. You must depress the button with your allen key
when removing the bolt kit. If there is air retained in the gun it will be purged before you remove
the bolt kit. The bolt kit should never be removed if there is an air supply feeding the SLG™.
MAINTENANCE
The basic maintenance for the SLG™ BOLT is to clean all surfaces of dirt, broken paint or other
debris. Also check for any wear and tear on the O-rings and change them if needed.
Remove the bolt kit with a
1
⁄
4
” allen key. Apply a thin layer of lube to all o-rings on the bolt
and plunger. Next, slide the bolt into the body. Make sure it moves smoothly.
Screw the back cap into the body.
If the SLG™ BOLT is not kept clean and well lubed, you will either start hearing leaks, or over long
period of time physical damage to the SLG™ BOLT components.
To troubleshoot leaks and other bolt problems consult the troubleshooting section at the
end of this manual.
SLG™ BOLT
OPERATION AND MAINTENANCE
1
1
3
4
2
2
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
14
15
