AIRPORT
ASSEMBLY AND MAINTENANCE
AIRPORT ADJUSTMENT AND
MAINTENANCE
The location of the airport
adapter can be moved
approximately 1
1
⁄
4
” back or
forward from the stock position
to fit your individual preference.
The Ultralite frame comes
equipped with an integrated
locking dovetail. There is a
locking screw located on the
bottom right side of the Ultralite
frame. It can be accessed with a
1
⁄
8
" allen key through a hole in the
grip panel. To unlock a part
attached to the dovetail of the
frame, turn the locking screw
counterclockwise one full turn
and slide part off the rail. To
attach a part to the rail, slide the part on and turn the locking screw
clockwise until part is firmly locked in place.
When screwing the air system into the airport, always check that the
threads on the air system and the airport are clean and not worn out. If
you think the threads are not in good condition, contact DYE Precision
or a professional store before screwing in the air system.
AIRPORT
ASSEMBLY AND MAINTENANCE
AIRPORT PIN DEPRESSOR
The airport on the SLG™ comes with an adjustable pin depressor. It’s preset to work with most of
the systems on the market, but if needed it can be adjusted.
To adjust the pin depressor remove the hose from the front of the airport by pushing the gray
plastic housing towards the fitting and pulling the hose out. Next, use a
5
⁄
64
” allen key to move the
set screw mounted inside the Airport. Turn the screw back a few turns so that the pin valve on the
air system will never be pressed.
Next:
1. Screw the air system into the airport all the way, no air should come out.
2. Turn the pin depressor screw in until a small amount of air starts to come out.
3. Turn the air system out about half a turn, air leak should stop.
4. Screw in the pin depressor screw enough for air to start leaking again.
5. Screw out the air system and connect hose again.
6. Now the pin depressor screw is set to the optimal point for
your air system.
If the screw is set too far out, the pin valve on the air system is
opened too early and air will leak out through the exhaust hole
on the top of the airport. If the screw is not in far enough,
the pin valve on the airport will never be opened or
will be opened too little for good flow.
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
18
19
