TRIGGER
ADJUSTMENT
SLG™ BOARD
SETTINGS AND FUNCTIONS
BATTERY
The 9V battery will last for about
20,000 shots. Please be aware that
there are substantial differences in
performance between different brands of
batteries. Use of high quality alkaline or
lithium ion batteries is recommended for
maximum battery life. If you plan not to
use your marker for a long period
of time (a month), it is
recommended that you remove the
battery from the marker. When the
battery voltage starts to go too low, the
marker will not fire with every trigger pull.
For tournament use, it is recommended to
change the battery for each tournament.
CHANGING THE BATTERY
The battery is housed on the right side of the grip
frame. To access the battery, remove the three screws holding the right side
grip panel down. Use a
3
⁄
32
” allen key. When inserting a new battery notice the
+ and - marks on the frame. The positive lead of the 9V battery goes to the left and the negative
lead to the right.
NOTE: If the marker will not
function with the eye on,
there is a good chance the
battery needs to be
changed
.
ADJUSTING YOUR TRIGGER
The trigger’s forward travel, over travel and spring tension
are fully adjustable so that the user can fine-tune the
trigger to his or her exact liking. You do not need to remove
the frame from the gun in order to adjust the trigger pull.
• There are two adjustment screws located on the right side
of the Ultralite frame and one adjustment screw behind the
trigger. The two screws on the side of the frame adjust the
travel of the trigger. The one located behind the trigger is
used to change the tension of the trigger spring.
• Use a
5
⁄
64
” allen key to make all desired adjustments.
TO ADJUST TRIGGER TRAVEL (SEE FIGURE 1)
• The screw toward the front of the trigger (
1
) controls the trigger’s length of pull.
NOTE: If this
screw is adjusted too far, the switch will be held down at all times and the marker will not fire.
•The screw toward the rear of the trigger (
2
) controls how far the trigger will travel after it
reaches the firing point.
NOTE: If this screw is adjusted too far, the trigger will not be allowed to
travel far enough to depress the switch and fire the marker.
TO ADJUST SPRING TENSION (SEE FIGURE 1)
• Turn the screw located through the hole in the trigger (
3
) in or out to reach the desired tension.
Fig. 1
2
1
3
• Be sure the trigger is not adjusted to the point where it is too sensitive
and may cause accidental discharge of the marker.
• Removing the trigger spring will cause premature wear on the microswitch,
resulting in failure.
•
Be sure you do not pinch the wires between the frame and body when
reattaching the frame to the body.
• A low battery will not be able to
power both the ACE eye and the
trigger switch, causing ACE eye failure.
• If the battery is low, the marker will
not fire with every trigger pull.
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
W
W
W
.
P
R
O
T
O
P
A
I
N
T
B
A
L
L
.
C
O
M
10
11
FIGURE 1
