3.0 Mounting
The Protégé® SE Integrated System Controller is supplied as a PCB only (Printed Circuit Board). It
is recommended that the gear plate style enclosures be used where possible, as this provides the
best mounting and installation solution as well as the required cable entry and
termination space.
When installing the Protégé® SE Integrated System Controller ensure that there is adequate
clearance around all sides of the cabinet enclosure and air flow to the vents of the enclosure are
not restricted.
It is recommended to install the Protégé® SE Integrated System Controller in a location that
will
facilitate easy access for wiring. It is also recommended that the Protégé® SE Integrated System
Controller is installed in electrical rooms, communication equipment rooms, closets or in an
accessible area of the ceiling.
Step 1
Insert the plastic standoffs in to the locations to mount the PCB board.
Step 2
Calculate the location and position of the cabinet enclosure and mark the holes for the keyhole
points in the top left and right locations. This will allow you to screw in the screws and then hang
the box on them adjusting the location to suit.
Step 3
Ensure a solid fixing point and screw in the two screws. Before tightening the top screws insert
the
tamper bracket in the slot provided on the right side of the cabinet enclosure.
Step 4
Fix the cabinet enclosure securely using the remaining mounting holes on the bottom left, right
and centre of the cabinet enclosure.
Step 5
If you are extending the Protégé®
SE Integrated System Controller by the addition of a
communications module or memory interface insert the 4 extended nylon standoffs through the
rear of the Protégé® SE Integrated System Controller.
Step 6
Insert the PCB in to the cabinet enclosure and mount using the plastic standoffs inserted during
step 1.
!
It is recommended to install the cabinet enclosure when the circuit board is not
installed on the plastic standoffs as this will reduce the risk of damage caused by
debris during the installation.
4