12
4.9 Expansion Connector
The Protégé® SE Integrated System Controller has an onboard expansion connector that is used to
connect serial communication, memory and special function interface devices. Connect the
interface card to the Protégé® SE Integrated System Controller as shown in the following diagrams.
For configuration information refer to the Protégé® Reference Manual and the Installation
Instructions provided with the interface device.
When installing the daughter board ensure that the plastic mounting hardware provided is
correctly inserted from the rear of the Protégé® SE Integrated System Controller. Pay attention to
the key location of the 40 Way Connector.
Figure 12 - Expansion Connector and Mounting Hole Location
Figure 13 - Connection and Mounting
!
Power to the Protégé® SE Integrated System Controller must be turned off when
connecting any hardware or system device to the Protégé® SE Integrated System
Controller. Failure to do so may damage the Protégé® SE Integrated System
Controller and expansion device.
!
If the Protégé® SE Integrated System Controller is used with the expansion
connector fitted then the second onboard reader port becomes unavailable.
