ENGLISH | AS-5020
15
FUNCTIONAL TEST
With (OPEN) switch position:
1. Switch exhaust air device ON and open the window >
exhaust air device must switch on.
2. Close the window > exhaust air device must switch off.
With (CLOSE) switch position:
1. Switch connected device ON and open the window >
the connected device must switch off.
2. Close the window > the connected device
must switch on.
MALFUNCTIONS
In individual cases cross-over with other similar radio devices
can cause malfunctions. In the normal case it is sufficient to
check the positioning of the components and if necessary,
to modify this.
TECHNICAL DATA
Mains voltage:
230 V ~, 50/60 Hz,
approx. 1 W
Mains switching capacity: 1800 W / 8A, at cos phi = 1
Radio range up to:
50 m
Frequency:
433.92 Mhz
Protection class:
IP 20 * only for dry rooms
Batterie (transmitter):
1 x 3V Lithium Typ CR 2477
(lifetime approx. 2 years)
Never carry out repairs yourself!
TUNING IN MORE THAN ONE TRANSMITTER
(MAX. 8 DEVICES)
1. Press and hold the sensor (4) on the Receiver
for 2 seconds. The CLOSED LED (5) begins to blink.
2. Insert a battery (CR 2477) into the TRANSMITTER
to be tuned in.
3. Activate the TRANSMITTER by holding the magnet
against the housing once and then removing it. The
POWER LED on the RECEIVER stops blinking and the
tuning-in procedure is completed.
4. Repeat steps a), b) and c) for each
individual transmitter.
5. Once a maximum of 8 TRANSMITTERS is tuned in, it is
impossible to add any more.
DELETING ONE OR ALL TRANSMITTERS
(MAX. 8 DEVICES)
Deleting individual TRANSMITTERS
1. Press and hold the sensor (4) on the receiver
for 2 seconds. The CLOSED LED (5) begins to blink.
2. Activate the TRANSMITTER to be deleted by holding the
magnet against the housing once and then removing
it. The POWER LED on the RECEIVER stops blinking and
the deletion procedure is completed.
Deleting all TRANSMITTERS
1. Press and hold the sensor (4) on the receiver
for 2 seconds. The CLOSED LED (5) begins to blink.
2. Press and hold the sensor (4) once more for 2 seconds.
The POWER LED on the RECEIVER stops blinking and the
deletion procedure for all TRANSMITTERS is completed.
AS-5020-3_I-Manual_150x180_Fin7.indd 15
08.09.15 11:48
