AS-5020 | ENGLISH
14
NOTE
: Without the tamper-proof plug guard (S) the
equipment does not function.
2. Next insert the RECEIVER into a mains electrical socket. If
the RECEIVER is working correctly, the POWER LED lights
up yellow.
3. Press and hold the sensor (4) on the RECEIVER for 2
seconds, until the red CLOSED LED begins to blink.
4. Insert the battery (CR 2477) into the TRANSMITTER. The
LED lights up briefly.
5. Activate the TRANSMITTER by holding the magnet
against the housing once and then removing it. The LED
built into the transmitter lights up. The POWER LED on
the RECEIVER stops blinking and the tuning-in procedure
is completed.
6. Now the TRANSMITTER is tuned in to the RECEIVER and
the AS-5020.3 is ready for use.
5. If the gap size of the window is less than the permissible
value for the opening size according to the table, the
window may only be able to achieve the required
opening size in the pivot position. There must also be a
minimum gap when the window is in the pivoted posi-
tion. The window contact shall be positioned in such a
way as to ensure the minimum gap size. We recommend
you ensure the minimum gap size using a spacer.
CODING BETWEEN TRANSMITTER AND RECEIVER
The transmitter is not factory encoded and must be trained
on the receiver when first operated.
Please follow sequence exactly!
1. Insert the plug of the device to be switched on (e.g.
fume extractor hood) into the RECEIVER, and mount the
tamper-proof plug guard (S).
AS-5020-3_I-Manual_150x180_Fin7.indd 14
08.09.15 11:48
