7
S-PARK
- rev.1.1_06_2020
3.5
Fixing the barrier on ground
Remove washers and bolts M10 screwed on ground plate, lay the
cabinet on the concrete basement and match protruding anchor
screws to slots of cabinet floor.
(Picture 6)
Use flat washers M10, grover washers and bolts M10 provided to fix
the cabinet to the ground plate.
Keep the barrier’s door facing inside the property.
Picture 5: Ground plate
Picture 6: Cabinet fixing
Picture 7: C
abinet to the ground plate
-
BASE PLATE
GROUND
PLATE
3.6
Balancing of the boom
3.6.1
Right hand and Left hand mounting
The barrier is available in one single version and can switch from
right to left hand and viceversa.
Once the barrier hand is determined, proceed to fit the spring
accordingly as shown in the above picture.
If you need to change the opening orientation, complete the installation
first and then follow the instructions rotating to 90° the equalizer
lever before repositioning the boom and spring.
ATTENTION: FOR SAFETY REASONS REMOVE THE BOOM JUST
WHEN IN VERTICAL POSITION
3.6.2
Mounting of the boom
After determing the closing orientation, if necessary cut the boom
according to the length needed.
We recommend to fit the cut side of the boom to the fixing plate.
Fix the bracket to the barrier plate: leave screws a bit loose, in order
to make the boom insertion as easy as possible.
Fit the boom inside the bracket and screw the 4 sets of washers and
screws M10.
(Picture 9)
Picture 9: bracket mounting
Right
version
Left
version
Picture 8: RIGHT (RH) and LEFT (LH) barrier version
