Protec TC-512A, Installation, Operation & Maintenance Manual

Page: 8 / 26

8-26
Before making the connections, check that the characteristics of your systems
correspond to those required by the machine.
Even small jobs done on the electrical system must be carried out by professional
personnel.
Connect the machine to the electrical network, which must be provided with line
fuses, a good earth plate in compliance with regulations in force and it must be
connected to automatic circuit breaker.
Warning: Should the tire changer be lacking in electric plug, so the user must set one,
which is at least 16A and which conforms to the voltage of the machine, in
compliance with the regulations in force.
3). Operation Test
When the pedal (1) is pressed down the turntable should turn in clockwise direction.
When the pedal is pulled up the turntable should turn in the anticlockwise direction.
Warning: if the turntable turns in the opposite direction to that shown, reverse the
wires in the three-phase plug.
Pressing the pedal (2) activates the bead breaker; when the pedal is released the
bead breaker returns to its original position.
Pressing the pedal (3) opens the four clamps; when the pedal is pressed again they
close.
Pressing the pedal (4) tilts the arm; when the pedal is pressed again it returns to its
working position.
When the pedal located on the left side of the machine is pressed down to the first
gear, air is released from the airline gauge. Gauge will indicate the pressure after
release of air.
When the pedal located on the left side of the machine is pressed down to the
second gear, air is released from the airline gauge along with a powerful jet from the
nozzles located on the turntable clamps.
Don't lean on the turntable during this operation, possible dirty dust on the turntable
could offend the operator's eyes. For the same reason, be carefully as not to
accidentally push the inflating pedal while working.
7. Operation