Protec TC-512A, Installation, Operation & Maintenance Manual

Page: 13 / 26

13-26
There is a pedal on the side of the machine.
This pedal has two positions. The first
position is for the inflation for the tire with tube.
Step the pedal lightly for several times during
the inflation. Make sure the reading on the
gauge does not exceed the manufacturer’s
limit
。
The second position is for the inflation for the tubeless tire, step the pedal down fully
to the bottom, and then make the pedal to the first position to continue the inflation.
Make sure that the reading on gauge doesn’t exceed the manufacturer’s limit.
Warning: the operator should wear safety goggles when operating.
2). Inflating tire using airline gauge:
Inflate a tire proceed as follows:
Connect the airline gauge fitting to the tire valve.
Make a last check to be certain that the tire and rim diameter correspond.
Between air jets, constantly check the pressure until required pressure has been
reached explosion hazard!
Never exceed 0.8MPa, when inflating tire on a fixed position. If a higher inflating
pressure is required remove the wheel from the turntable and continue the inflation
inside a special protection cage (commerciallyavailable).
Never exceed the max. Inflating pressure given by the tire manufacturer.
Always keep hands and body back from inflating tire.
Only specially trained personnel are allowed to perform these operations .do not
allow other persons to operate or to stay near the tire changer.