S3964R
♦
ProLinx Gateway
Configure the Gateway
Siemens 3964R Protocol
Driver Manual
Page 18 of 64
ProSoft Technology, Inc.
April 14, 2009
Use CTS Line
Yes or No
This parameter specifies if the CTS modem control line is to be used. If the
parameter is set to No, the CTS line will not be monitored. If the parameter is set
to Yes, the CTS line will be monitored and must be high before the module will
send data. Normally, this parameter is required when half-duplex modems are
used for communication (2-wire).
Swap
0 or 1
This parameter specifies whether bytes should be swapped. 0 = No data byte
swapping, 1 = Data byte swapping.
Priority
0 or 1
This parameter specifies whether the module is high priority or low priority with
respect to the CP. 0 = High priority, 1 = Low Priority.
Protocol
0 or 1
0=3964 RK512, 1=3964
ACK Delay
Number of milliseconds to wait for ACK. The default is 1000 ms.
Setup Attempts
Number of times to try to connect to CP (Default 6)
Transmit Attempts
Number of times to try to transmit to CP (Default 6)
DB Block Size
16 to 300 words
Size of message block to use for multi-block message transfers through the
database.
DB Block Timeout
1 to 65535 milliseconds
Timeout value to use while waiting to send/receive next message block during
multi-block message transfers through the database.
