Contents
MVI69-GEC ♦ CompactLogix or MicroLogix Platform
User Manual
Page 72 of 86
ProSoft Technology, Inc.
February 18, 2014
6.3.1 Ethernet Connection
The MVI69-GEC module has an RJ45 port located on the front of the module, labeled
Ethernet
, for use with the TCP/IP network. The module is connected to the Ethernet network
using an Ethernet cable between the module’s Ethernet port and an Ethernet switch or hub.
Note:
Depending on hardware configuration, you may see more than one RJ45 port on the module. The
Ethernet port is labeled
Ethernet
.
Warning:
The MVI69-GEC module is NOT compatible with Power Over Ethernet (IEEE802.3af / IEEE802.3at)
networks. Do NOT connect the module to Ethernet devices, hubs, switches or networks that supply AC or DC
power over the Ethernet cable. Failure to observe this precaution may result in damage to hardware, or injury to
personnel.
Important:
The module requires a static (fixed) IP address that is not shared with any other device on the
Ethernet network. Obtain a list of suitable IP addresses from your network administrator BEFORE configuring
the Ethernet port on this module.
Ethernet Port Configuration - wattcp.cfg
The wattcp.cfg file must be set up properly in order to use a TCP/IP network connection.
You can view the current network configuration in
Viewing the WATTCP.CFG File on the
module (page 51) from the Diagnostics menu. From the Main menu, select
[@]
(Network
Menu) and
[V]
(View) options when connected to the Ethernet or Configuration/Debug port.
For more information on serial port access, see the chapter on Diagnostics and
Troubleshooting (page 40).
6.3.2 RS-232 Configuration/Debug Port
This port is physically an RJ45 connection. An RJ45 to DB-9 adapter cable is included with
the module. This port permits a PC-based terminal emulation program to view configuration
and status data in the module and to control the module. The cable pinout for
communications on this port is shown in the following diagram.
