ProSoft Technology, Inc.
Page 3 of 151
Important Installation Instructions
Power, Input, and Output (I/O) wiring must be in accordance with Class I, Division 2 wiring methods, Article
501 to 4 (b) of the National Electrical Code, NFPA 70 for installation in the U.S., or as specified in Section
18-1J2 of the Canadian Electrical Code for installations in Canada, and in accordance with the authority
having jurisdiction. The following warnings must be heeded:
WARNING
- EXPLOSION HAZARD - SUBSTITUTION OF COMPONENTS MAY IMPAIR SUITABILITY
FOR CLASS I, DIV. 2.
WARNING
- EXPLOSION HAZARD - WHEN IN HAZARDOUS LOCATIONS, TURN OFF POWER BEFORE
REPLACING OR WIRING MODULES.
WARNING
- EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS POWER HAS BEEN
SWITCHED OFF OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
Class 2
MVI (Multi-Vendor Interface) Modules
WARNING - EXPLOSION HAZARD - DO NOT DISCONNECT EQUIPMENT UNLESS POWER HAS BEEN
SWITCHED OFF OR THE AREA IS KNOWN TO BE NON-HAZARDOUS.
AVERTISSEMENT - RISQUE D'EXPLOSION - AVANT DE DÉCONNECTER L'ÉQUIPEMENT, COUPER
LE COURANT OU S'ASSURER QUE L'EMPLACEMENT EST DÉSIGNÉ NON DANGEREUX.
Warnings
North America Warnings
Power, Input, and Output (I/O) wiring must be in accordance with Class I, Division 2 wiring methods, Article
501 to 4 (b) of the National Electrical Code, NFPA 70 for installation in the U.S., or as specified in Section
18-1J2 of the Canadian Electrical Code for installations in Canada, and in accordance with the authority
having jurisdiction. The following warnings must be heeded:
A
Warning - Explosion Hazard - Substitution of components may impair suitability for Class I, Division 2.
B
Warning - Explosion Hazard - When in hazardous locations, turn off power before replacing or rewiring
modules.
C
Warning - Explosion Hazard - Do not disconnect equipment unless power has been switched off or the
area is known to be non-hazardous.
Avertissement - Risque d'explosion - Avant de déconnecter l'équipement, couper le courant ou
s'assurer que l'emplacement est désigné non dangereux.
D
Suitable for use in Class I, Division 2 Groups A, B, C and D Hazardous Locations or Non-Hazardous
Locations.
ATEX Warnings and Conditions of Safe Usage
Power, Input, and Output (I/O) wiring must be in accordance with the authority having jurisdiction.
A
Warning - Explosion Hazard - When in hazardous locations, turn off power before replacing or wiring
modules.
B
Warning - Explosion Hazard - Do not disconnect equipment unless power has been switched off or the
area is known to be non-hazardous.
C
These products are intended to be mounted in an IP54 enclosure. The devices shall provide external
means to prevent the rated voltage being exceeded by transient disturbances of more than 40%. This
device must be used only with ATEX certified backplanes.
D
DO NOT OPEN WHEN ENERGIZED.
Summary of Contents for MVI56E-AFC
Page 78: ......