Proroute H685, User Manual

Page: 13 / 109

E-mail: support@proroute.co.uk www.proroute.co.uk
When the router is reset, this sequence above is also a good indication that the modem has
reset correctly as the Wi-Fi is enabled by default.
(For how to factory reset go to section
3.3.6)
If a SIM card is inserted, and the antennas are receiving signal, the signal light will flash blue.
Once the correct APN settings of the SIM are entered into the router, an internet connection
will be established and the cell light will stop flashing and be solidly on.
If the router is receiving mobile signal, the signal light will flash blue. The faster the flash, the
stronger the signal. (see table below for details). More details of signal strength is found in the
web GUI. Status > Network.
- If LAN cable is connected and transmitting data, it will be flashing.
- If WiFi is enabled, the WiFi light will be solid on, and flickering if transmitting.
- If VPN tunnel is not connected, light is off. If VPN tunnel is connected, light is solid.
- If all lights are solid on and unchanging, most likely there is a system error. Try to factory
reset the router.
LED Colour Indication Light Description
SYS
Solid on for 25 seconds On for 25 seconds after power supply
Green Flashing System set-up normally
Off, or solid on after 25 seconds System set-up failure
LAN
Flashing Data transmission in Ethernet
Green Off No LAN cable connected, or error.
Solid on Ethernet is connected
VPN
Green Solid on
IPSec VPN tunnel is set-up and
connected
Off
IPsec VPN tunnel set-up failure or
inactivated
CELL
Orange Flashing Not connected to internet.
Solid on Internet access established.
WiFi
Green Solid on Enable
Off Disable
WAN
Flashing Transmitting data
Green Off No WAN cable connected, or error.
Solid on Ethernet is connected
Signal Off
No signal, or signal checking system
not ready