Proroute H685, User Manual

Page: 11 / 109

E-mail: support@proroute.co.uk www.proroute.co.uk
Note: When powering the router via the terminal block, the power cable should be wired with the
Please note
1.
Take care to connect the power cable correctly. We suggest you double check
before switching it on. Incorrect wiring can damage the equipment.
2.
Power terminals: Pin 1 and Pin 2
3.
Here: Pin 2 is “GND”, PIN 1 is power input “VCC” (DC7~30V).
PIN Signal Description Note
1 VCC +7-30V DC Input Current: 12V/1A
2 GND Ground
3 TX Transmit Data
4 RX Receive Data
5 PGND Ground
6 RST Reset
Reset Pin has the same function
as the reset button at top of device.. In the
To reset with pin, short both
RST and GND terminals for
3 Seconds. This will restore the
Router to factory default settings.
This usually takes 2-4 minutes.
7 DIO0
General Purpose
I/O
8 DIO1
General Purpose
I/O
9 NC/DIO2 Not connect Reserved for DIO2
10 NC/DIO3 Not connect Reserved for DIO3