PROGRAMMING STARTS IN
MAIN MENU
PRESS PROGRAM BUTTON ONE (1) AT A TIME IN THE MAIN MENU MODE.
1
NORMAL OPERATION:
On power up, the meter usually starts in
NORMAL
operating mode. The Tachometer will read en-
gine’s RPM. Press the center “mode” button to advance to
2
PEAK PLAYBACK
2
PEAK PLAYBACK:
Reads the highest value displayed on the meter since the last time the “
Peak
” value was displayed.
Pressing the “Down” or “Up” control button will control the gauge dial illumination. Press the center
“Mode” button to advance to
3
HIGH RACING RED-LINE SETTING
3
HIGH RACING RED-LINE SETTING:
Sets the point at which “
HIGH
” warning RED-LINE is reached for that specific gauge. The “Down and
“Up” buttons will move the dial pointer to select “Maximum RED-LINE”. During normal operation the
gauge constantly monitors the sensor value and compares it to the “
HIGH
” RED-LINE. If the
threshold is exceeded, the red “
HI
” indicator is turned on and an output signal generated. Press the
center “Mode” button to save the setting and advance to
4
LOW RACING YELLOW-LINE
SETTING
4
LOW RACING YELLOW-LINE SETTING:
Set the Minimum RED-LINE: Sets the point at which “
LOW
” warning threshold is reached for that
specific gauge. The “Down” and “Up” buttons will move the dial pointer to select the
LOW
RACING YELLOW-LINE SETTING
. During normal operation the gauge constantly monitors the
sensor value and compares it to the “
LOW
” threshold. If the sensor value drops below the threshold,
the yellow “
LOW
” indicator is turned on and an output signal generated. Press the center “Mode”
button save the setting and advance to
5
C
O
L
O
R
S
C
H
E
M
E
5
C
O
L
O
R
S
C
H
E
M
E:
Set Faceplate Color Scheme: Operator can select the color of the gauge dial illumination. Each time
you press the “Down” control button you scroll through dial color selection until the dial light goes
off. Then press the “Up” button to reverse the scroll. Select your dial color illumination by pressing
the center “Mode” button to save the setting and advance to
NORMAL OPERATION.
6
DIAL BRIGHTNESS:
Adjust the dial brightness for day or evening driving conditions The RIGHT and LEFT command but-
tons will dim or brighten the faceplate illumination. Press the center “Mode” button to save the set-
ting and advance you to
NORMAL OPERATION
Programming Instructions for : RPM Tachometer
2 1/16” Controller
