Wiring Installation Instructions for : RPM Tachometer
2
1/16
” Controller
4
THERE ARE THREE SECTIONS TO THIS MANUAL: WIRING INSTRUCTIONS, PROGRAMMING
INSTRUCTIONS AND FLOW CHART PROGRAMMING INSTRUCTIONS. PLEASE READ EACH
SECTION CAREFULLY BEFORE ATTEMPTING TO INSTALL OR OPERATE THIS PRODUCT.
WARNING:
• ALL INSTRUCTIONS IN THIS MANUAL MUST BE FOLLOWED TO INSURE SAFE
INSTALLATION AND OPERATION OF THIS PRODUCT.
• NEVER DISASSEMBLE MODIFY OR TAMPER WITH THIS PRODUCT. THIS COULD CAUSE
DAMAGE AND MAKE THEM UNSAFE TO USE. TAMPERING WITH THE PRODUCT WILL VOID
THE LIMITED WARRANTY.
• INSTALLATION MUST BE PERFORMED BY AN EXPERIENCED AUTOMOTIVE TECHNICIAN.
• INSTALLER MUST USE SAFETY GLASSES.
• DISCONNECT THE NEGATIVE BATTERY TERMINAL BEFORE BEGINNING INSTALLATION.
PROPARTS LLC IS NOT RESPONSIBLE FOR DAMAGE TO ENGINE, VEHICLE OR UNIT CAUSED
BY ELECTRICAL SHORTS.
• DURING INSTALLATION, DO NOT INTERFERE WITH ANY EXISTING CONNECTIONS OR
WIRES.
• ALL ELECTRICAL CONNECTIONS USE SOLDER LESS CONNECTORS AND INSULATE ALL
CONNECTIONS WITH ELECTRICAL TAPE.
• AVOID WIRING NEAR ENGINE, EXHAUST SYSTEM, TURBINE OR ANY AREA THAT MAY
RESULT IN DAMAGE.
• DISCONTINUE USE OF THE PRODUCT IF SMOKE OR A STRANGE ODOR IN PRESENT.
CAUTION
• PROPARTS LLC IS NOT RESPONSIBLE FOR INCORRECT INSTALLATION OR PROGRAMMING
OF SPEK™ GAUGES OR CONTROLLERS.
• SPEK™ GAUGES AND CONTROLLERS ARE DESIGNED FOR 12V DC ELECTRICAL SYSTEMS
WITH A NEGATIVE GROUND.
• DO NOT ADJUST THE GAUGES OR GAUGE PROGRAM WHILE DRIVING
• OBEY ALL RULES AND REGULATIONS OF HIGHWAY AND STREET DRIVING.
• INSTALL SENSOR AND WIRE AWAY FROM HIGH HEAT AND / OR VIBRATION AREAS.
• USE CARE WHEN CONNECTING OR DISCONNECTING THE WIRING HARNESS. PULL OUT
EACH CONNECTOR WHILE PRESSING THE LOCK OF THE CONNECTOR FIRMLY.
• IF THE BATTERY TERMINAL IS DISCONNECTED, THE AUDIO, CLOCK AND OTHER MEMORY
DATA MAY BE LOST. THE NECESSARY DATA WILL HAVE TO BE RESET AFTER INSTALLATION.
