PRO 10 PB (PBE)
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
19
4.4.3. Installing
Remove
the
existing
expanding
mandrel.
To
do
this, loosen the nut and use the 5 mm
hex wrench to loosen the set screw (
1
, Fig. 3) to at least one turn. Then, rotate the
spoke handles to the left to disengage the mandrel from the machine.
Use the same 5 mm hex wrench to unscrew the screws (
3
, Fig. 2) and remove
the existing tool holders.
Next, remove the machine handle by unscrewing three screws with washers (
1
,
Fig. 7), and use them to install the holder with two tripper blocks (
2
). Then, use the
4 mm hex wrench to tighten the set screws
3
at both sides of the holder, and install
the milling unit to the spindle disk (
4
) with six screws using the 5 mm hex wrench.
Fig. 7.
Installing the flange facing attachment
Depending on the diameter of the flange to be machined, select either the
internal (
Ø90–451, 3.54–17.76’’) or external insert holder (Ø147–508, 5.79–20.00’’),
onto which install a cutting insert using the supplied screwdriver (
1
, Fig. 8). Then, use
the 4 mm hex wrench to tighten the clamp
2
, and slide the insert holder under the
clamp (
3
) and tighten with the screws
4
.
1
2
3
M6x35
M6x30
4
