3
Since the controller can stay in this mode for an indefinite time, make sure that
actuator connected to the controller can be supplied with power for a long
time.
4.4 TECHNICAL DATA OF THE REMOTE CONTROL
PROMIX-CR.TX.01
Output power, мW, not more than
10
The length of the code, byte
4
Number of code combinations
16777216
Battery supply voltage (type 23А), V
12
Current consumption with pressed button, мА, not more than
5
5.
DESIGN AND PRINCIPLE OF OPERATION
The controller Promix-CR.RX.03 contains: a connector for connection of the actuator, a mode
jumper J1, a power cord for connection to 220V power grid (1.4 m long), an antenna wire. The
overall dimensions of the controller Promix-CR.RX.03: 111x58x50 mm (LxWxH).
When pressing the control button on the remote control Promix-CR.TX.01, it sends a unique
code via a radio channel. The controller Promix-CR.RX.03 receives the sent code and, if this code
is recorded in the controller memory (see Section 7), activates its output contact for the
programmed time (the supply voltage is applied to or removed from the actuator), what is
accompanied by a continuous beep signal.
If the current in the circuit of the actuator exceeds the value of the tripping current, the power
supply will switch off. It can be restored by reconnecting the controller to the power grid. The state
of the controller after the current protection trips is indicated by short intermittent sound signals.
When holding down the remote control button for more than 7 seconds, the controller switches
into the permanently open actuator mode. The controller emits a short trill and then produces
single beeps. To close the actuator, press the remote control button. The controller will close the
actuator and emit a beep signal.
