2
4.
TECHNICAL DATA
4.1 TECHNICAL DATA OF THE POWER SUPPLY UNIT
The power supply unit of the controller powers the receiver, controller unit, and actuator. The
power supply unit is a pulse type, with galvanic isolation of primary and secondary circuits. The
power supply unit has a built-in overcurrent and short-circuit protection for the load circuit.
Supply voltage (50 Hz), V
180-230
Output voltage (direct current), V
12
Rated output current, A
1.0
Maximum output current during 1 minute, А, not more than
1.5
Maximum load current (tripping current), A, not more than
2.0
4.2 TECHNICAL DATA OF THE CONTROLLER UNIT
The controller unit is designed on the same board as the receiver. The controller unit performs
the following functions:
•
programming of remote controls and control time of the actuator;
•
applying or removing supply voltage to/from the actuator for a specified time on the signals
of the programmed remote controls;
•
disconnecting the actuator from the power supply unit (protection) when the current
consumption by the actuator exceeds the preset level;
•
audible signaling of the controller current operations.
Supply voltage (direct current), V
12
Current consumption, mA
5
Protection tripping current (disconnection of the actuator), A
2.0
Memory capacity of the remote controls, pcs.
7
Range of programmed open lock time, s
1-15
4.3 TECHNICAL DATA OF THE RECEIVER
Supply voltage (direct current), V
12
Current consumption, mA
2
Operating frequency, MHz
433.92
Sensitivity, µV
7
Reception range of signals from the remote control Promix-CR.TX.01 (in
direct visibility and absence of interference), m, not less than
30
