SuperTrak SX6000™ User Manual
Chapter 4
- 29 -
Installing Drivers
Windows NT 4.0
Installing Driver in Existing Windows NT 4.0 System
The following procedure details the installation of the SuperTrak SX6000 drivers on a
Windows NT version 4.0 or later system. Under Windows NT 4.0, insert the included
“SuperTrak SX6000 Driver” diskette in drive A: when prompted for the drivers.
(1)
From the “Start” menu, point to “Settings” then click “Control Panel”.
(2)
From the “Control Panel”, double-click the “SCSI Adapters” icon.
(3)
From the “SCSI Adapters” window, choose the “Drivers” tab the click “Add”.
(4)
From the “Install Driver” window, choose “Have Disk” and insert Driver diskette.
Enter the directory location of the driver in the text box. Or use “Browse” and
select filename “sptrak.inf” and click “Open”.
(5)
From the “Select OEM Option” window, select "WinNT Promise SuperTrak
SX6000 (tm) IDE RAID Controller" and click “OK”.
(6)
From the “Select SCSI Adapter Option” window click “Install” to initiates the
installation operation.
After a successful installation, the “SCSI Adapter Setup” dialog box will appear
which states that the, "WinNT Promise SuperTrak SX6000 (tm) IDE RAID
Controller" has been installed.
(7)
Save all the settings, shut down, and restart the server.
To check if the driver installation was successful, perform the following steps:
(1)
After restarting the system, return to “Control Panel”.
(2)
From the “Control Panel”, double-click the “SCSI Adapters” icon.
(3)
From the “SCSI Adapters” window, choose the “Devices” tab. You should now
see "WinNT Promise SuperTrak SX6000 (tm) IDE RAID Controller" listed.
Installing Driver During New Install of Windows NT 4.0
Under Windows NT 4.0, insert the included “SuperTrak SX6000 Driver” diskette in drive
A: when prompted for the drivers.
(1)
Installation:
•
Floppy Install:
Boot the computer with the Windows NT installation diskettes.
•
Floppyless Install:
Boot from floppy and type “WINNT /B”. After files have
been copied, the system will reboot. On the reboot, press [F6] when the
message “Setup is inspecting your computer’s hardware configuration”
appears.
•
CD-ROM Install:
Boot from the CD-ROM and press [F6] when the message
“Setup is inspecting your computer’s hardware configuration.”
Summary of Contents for SuperTrak SX6000
