SuperTrak SX6000™ User Manual
Chapter 5
- 38 -
LED Display Codes
LED displays appear on the backplane of the SuperTrak SX6000 controller.
NOTE: The LEDs on the backplane of the SuperTrak SX6000 controller go through
various patterns throughout the power-on and initialization process. However, only
three different conditions remain constant.
Event:
LEDs on the card backplane turn on a few seconds after system power-
on and show a pattern of ON-OFF-OFF-ON (1001).
Cause:
This is the normal condition of the LEDs after power-on indicating that
the SuperTrak SX6000 firmware loaded properly on the controller, and
that the cache memory DIMM is functioning. This pattern requires no
special attention.
Event:
LEDs on the card backplane turn on a few seconds after power-on and
move in a back and forth pattern.
Cause:
This is the operational mode of the LEDs after the card has been
initialized at power up. This indicates that the HDM thread is loaded
and running correctly.
Event:
LEDs on the card backplane turn on a few seconds after system power-
on and show a pattern of ON-OFF-ON-OFF (1010).
Cause:
This condition is caused by the DIMM memory on the SuperTrak
SX6000 controller. It is either not installed correctly, has problems with
the connections, or may be an unsupported type of memory DIMM.
Make sure the DIMM is seated correctly before trying an alternate
memory module to correct the problem.
Summary of Contents for SuperTrak SX6000
