65
promesstec GmbH
I Niedersachsenstraße 4 I D-48465 Schüttorf I Tel.:+49 (0)5923/ 90 229 0 I Fax:+49 (0)5923/ 90 229 29
E-Mail: [email protected] I Internet: www.promesstec.com
*Note
Cards larger than 2GB cannot be normally formatted to 512B clusters, so the card must
be split into two partitions where an active partition must always be lower than 2GB,
formatted to FAT32 with 512B clusters.
The formatted card can be bought as accessory to the expansion module.
1) MBus
Power off, insert the expansion card into the available slot and fix it with an M3 screw.
After power off, connect the MBus communication line to the terminals of the expansion
module.
communication parameters:
2400Bd
paEven
8 data bits
1 stop bit
Address: last two digits of the serial number
Diagnostics:
Reception and transmission can be diagnosed in the SET menu, communication Line
1 - RS485 settings.
Rx
– reception on line 1 (RS4858, MBus/Modbus)
Tx
– transmission on line
1 (RS485, MBus/Modbus)
R1
– reception on line
2 (MBus Erweiterungsmodul)
T1
– transmission on line
2 (MBus Erweiterungsmodul)
7. Application information
Installation of the sensor with a separate evaluation unit:
First of all, it should be determined which type of installation is to be used, whether
the mounting is to be behind the electronics or under the electronics. The mounting
corner is fixed to the wall with screws. The evaluation unit is mounted to the fas-
tening and wired. The cables should form a suspension so that no condensation
water runs into the housing.