2 - 17
Assembly Procedure
Lower Shaft Unit Assembly
1. Insert the push spring in the feed adjuster assembly which is then inserted into the shaft receptacle of the base
plate from the left.
2. Insert the feed arm receptacle to the end face of the base plate.
3. Snap on the retainer ring E6 in the retainer spring groove on the left of the lower shaft and attach the thrust
washer on the shaft from the left.
4. Insert the lower shaft assembly into the base plate.
5. Attach the lower shaft metal on the left of the lower shaft, set the metal retainer B, and secure with the three
screws (screws, bind M 3
×
6).
6. After attaching the thrust washer and the set collar on the left of the lower shaft, slide the set collar toward
the metal, and tighten the screw (set screw, socket (CP) M 4
×
4).
7. Insert the vertical feed shaft into the base plate, slide the vertical finger and the washer on the shaft, and
attaché the retainer rings E3 on the inner left of the base plate as well as outside of the vertical finger (on both
the left and the right).
1
4
3
3
5
5
5
5
6
6
6 6
5
1
7
7
7
7
7
7
2
www.promelectroavtomat.ru
