Promega Corporation ·
2800 Woods Hollow Road
·
Madison, WI 53711-5399 USA
·
Toll Free in USA 800-356-9526
·
Phone 608-274-4330
·
Fax 608-277-2516
· www.promega.com
Printed in USA.
Part# TM300
2/08
Page 13
III.C. Operational Mode Setup
(i) Plugging the Instrument into the Power Outlet
1.
Once the Magnetic Rod Assembly/Plunger bar shipping anchors, Platform shipping anchors and all
packaging materials have been removed, you can connect the instrument to a power outlet.
2.
Ensure that the power switch is in the off position. The power switch is located next to the power cord
connection on the back of the instrument.
3.
Connect the power cord to the back of the Maxwell
®
16 Instrument.
4.
Plug the power cord into a wall outlet. See Section I.G for power requirements.
5.
Close the door.
6.
Turn the instrument on.
7.
Once turned on, the instrument will display the firmware version number and operational mode
setting, and proceed through a self-check.
8.
Connecting to the serial port on the back of the instrument is not required. Store the RS-232 Cable in a
location near the instrument for future use.
Figure 4. The upper (magnetic rod assembly/plunger bar) shipping anchors and the platform shipping anchors on the
Maxwell
®
16 Instrument.
Platform shipping anchors
6923T
A
Upper shipping anchors
6922T
A
tm300.0208_Corrected.qxp 3/11/2008 10:40 AM Page 13
